SmartCut is a very light and simple to use windshield cut out tool. Due to its small size it can be used for windshields, backlights and also quarter lights. Thanks to it’s compatibility with steel wire (SmartCut Square Wire) and PE fiber (SmartCut Fiber) it can be used on all types of windshields.

Protect the car body with tape
Bild: ??????

Protect the car body with tape. Pierce the existing adhesive with the awl, preferably in one of the bottom corners

Fix the wire/fiber to the awl and pull it inside

Fix the wire/fiber to the awl and pull it inside. Pull 1x the diagonal length of the windshield inside

Place the wire/fiber completely around the windshield

Place the wire/fiber completely around the windshield. Make sure it is positioned at the place of the existing adhesive. Lock the wire/fiber in the reel

lace the wire/fiber on the SmartCut

Place the wire/fiber on the SmartCut. Position the SmartCut at the corner of the windshield as shown. Wind up the wire/fiber using the ratchet lever

Wind up the wire/fiber

Wind up the wire/fiber to the maximum angle of 80° to the cutting direction. Cut carefully around the corner

Move the SmartCut to the next corner

Move the SmartCut to the next corner, release the wire/fiber to reposition. Repeat the process

Continue as shown until the adhesive is cut completely

Continue as shown until the adhesive is cut completely

It may happen that the resistance on some spots will be higher. On these spots it helps to saw with the lever. This will cause sawing on the wire/fiber and the spot will release easier.